Standard 1

Electrical/Electronic Systems

Benchmark 1

General Electric System Diagnosis

Indicator 1

Identify and interpret electrical/electronic system concern; determine necessary action. P-1

Indicator 2

Research applicable vehicle and service information, such as electrical/electronic system operation, vehicle service history, service precautions, and technical service bulletins. P-1

Indicator 3

Locate and interpret vehicle and major component identification numbers (VIN, vehicle certification labels, and calibration decals). P-1

Indicator 4

Diagnose electrical/electronic integrity for series, parallel and series-parallel circuits using principles of electricity (Ohm's Law). P-1

Indicator 5

Use wiring diagrams during diagnosis of electrical circuit problems. P-1

Indicator 6

Demonstrate the proper use of a digital multimeter (DMM) during diagnosis of electrical circuit problems. P-1

Indicator 7

Check electrical circuits with a test light; determine necessary action. P-2

Indicator 8

Measure source voltage and perform voltage drop tests in electrical/electronic circuits using a voltmeter; determine necessary action. P-1

Indicator 9

Measure current flow in electrical/electronic circuits and components using an ammeter; determine necessary action. P-1

Indicator 10

Check continuity and measure resistance in electrical/electronic circuits and components using an ohmmeter; determine necessary action. P-1

Indicator 11

Check electrical circuits using fused jumper wires; determine necessary action. P-2

Indicator 12

Locate shorts, grounds, opens, and resistance problems in electrical/electronic circuits; determine necessary action. P-1

Indicator 13

Measure and diagnose the cause(s) of excessive key-off battery drain (parasitic draw); determine necessary action. P-1

Indicator 14

Inspect and test fusible links, circuit breakers, and fuses; determine necessary action. P-1

Indicator 15

Inspect and test switches, connectors, relays, solid state devices, and wires of electrical/electronic circuits; perform necessary action. P-1

Indicator 16

Repair wiring harnesses and connectors. P-1

Indicator 17

Perform solder repair of electrical wiring. P-1

Benchmark 2

Battery Diagnosis and Service

Indicator 1

Perform battery state-of-charge test; determine necessary action. P-1

Indicator 2

Perform battery capacity test; confirm proper battery capacity for vehicle application; determine necessary action. P-1

Indicator 3

Maintain or restore electronic memory functions. P-1

Indicator 4

Inspect, clean, fill, and replace battery. P-2

Indicator 5

Perform slow/fast battery charge. P-2

Indicator 6

Inspect and clean battery cables, connectors, clamps, and hold-downs; repair or replace as needed. P-1

Indicator 7

Start a vehicle using jumper cables and a battery or auxiliary power supply. P-1

Benchmark 3

Starting System Diagnosis and Repair

Indicator 1

Perform starter current draw tests; determine necessary action. P-1

Indicator 2

Perform starter circuit voltage drop tests; determine necessary action. P-1

Indicator 3

Inspect and test starter relays and solenoids; determine necessary action. P-2

Indicator 4

Remove and install starter in a vehicle. P-1

Indicator 5

Inspect and test switches, connectors, and wires of starter control circuits; perform necessary action. P-2

Indicator 6

Differentiate between electrical and engine mechanical problems that cause a slow-crank or no-crank condition. P-2

Benchmark 4

Charging System Diagnosis and Repair

Indicator 1

Perform charging system output test; determine necessary action. P-1

Indicator 2

Diagnose charging system for the cause of undercharge, no-charge, and overcharge conditions. P-1

Indicator 3

Inspect, adjust, or replace generator (alternator) drive belts, pulleys, and tensioners; check pulley and belt alignment. P-2

Indicator 4

Remove, inspect, and install generator (alternator). P-1

Indicator 5

Perform charging circuit voltage drop tests; determine necessary action. P-1

Top of page

Standard 2

Career Development Activities

Benchmark 1

SkillsUSA PDP 1 Training Degree

Indicator 1

Complete a self-assessment and identify individual learning styles.

Indicator 2

Discover self-motivation techniques and establish short-term goals.

Indicator 3

Determine individual time-management skills.

Indicator 4

Define future occupations.

Indicator 5

Develop awareness of cultural diversity and equity issues.

Top of page

USD 250 Home Page
General info: Vicki Horton Tech info: Rick Duling
Webmaster: Noah Grotheer
© Pittsburg Public Schools